Author |
Topic: Velocity mapping with input from midi yoke? (Read 1949 times) |
|
Sonus
Member
MIDI-OX Rules!
Posts: 78
|
 |
Velocity mapping with input from midi yoke?
« on: Jun 21st, 2016, 4:04am » |
 Quote  Modify
|
This inverted velocity map seems not to work with midi input from midi yoke?
It only works when input NoteOn = -1 but then also NoteOn = 0 is converted.
There's no problem with the virtual loopMIDI cable or an USB-MIDI interface.
|
|
 IP Logged |
|
|
|
Breath
Administrator
Gender: 
Posts: 1030
|
|
Re: Velocity mapping with input from midi yoke?
« Reply #1 on: Jun 21st, 2016, 8:35pm » |
Quote Modify
|
Hi Sonus
It works perfectly for me.
The datamap used on both links in the MidiPort Routing window.
Keyboard ->DataMap->Yoke1->DataMap->Yoke2
....7F...........................01......................7F...
....01...........................7F......................01
and values in between.
It also works for global datamap
Keyboard ->Yoke1->Yoke2 - datamap on
I did completely un-route my setup and rerouted each time I tested, so I can be sure it wasn't that.
The only way I could do it is when the links had the map and the global map was also on.
So it mapped the velocity then mapped it back again before it was sent to the output.
All the best
Royce
|
| « Last Edit: Jun 21st, 2016, 8:41pm by Breath » |
IP Logged |
|
|
|
Sonus
Member
MIDI-OX Rules!
Posts: 78
|
|
Re: Velocity mapping with input from midi yoke?
« Reply #2 on: Jun 22nd, 2016, 2:17am » |
Quote Modify
|
Hi Royce, could you try these configurations? Thx.
1. sequencer -> midi yoke -> port map -> output
2. sequencer -> loop midi -> port map -> output
|
|
IP Logged |
|
|
|
Breath
Administrator
Gender:
Posts: 1030
|
|
Re: Velocity mapping with input from midi yoke?
« Reply #3 on: Jun 22nd, 2016, 5:48am » |
Quote Modify
|
With Sonar driving and global Datamapping turned off, just the map loaded into both the MidiYoke and loopMidi connections all works OK.
I tried two tests sending both to MidiYoke 2 and to MS GS wavetable synth.
All as they should be.
Just checking the datamapping :
All boxes NOT selected on the datamap Translation Map window.
On the Define MApping page, again, NO boxes selected.
I believe these are also saved in the mox file but don't show up on the Translation view that you show.
All the best
Royce
|
| « Last Edit: Jun 22nd, 2016, 5:51am by Breath » |
IP Logged |
|
|
|
Sonus
Member
MIDI-OX Rules!
Posts: 78
|
|
Re: Velocity mapping with input from midi yoke?
« Reply #4 on: Jun 22nd, 2016, 7:45am » |
Quote Modify
|
Well, if my test file is played from midibar, both configurations finally do work.
Thanks!
Sonus
|
|
IP Logged |
|
|
|
|
User Forum ::
Powered by YaBB
Home 
Help 
Search 
Members 
Login 
Register
Reply
Notify of replies
Send Topic
Print