MIDI-OX User Forum - Print Page


    
      
        MIDI-OX User Forum
        (http://www.midiox.com/cgi-bin/yabb/YaBB.pl)
      

        MIDI-OX >> Mapping Questions >> Insert Data Mapping for Controller
        
(Message started by: Fletsch on Sep 13^th, 2008, 9:49am)

Title: Insert Data Mapping for Controller
Post by Fletsch on Sep 13^th, 2008, 9:49am

Hi all

I'm new with this Programm. I wanna use it to map some command from a dj midi console to the dj software. how must i insert such a line into the data mapping? I tried a lot but nothing works.

00050B40 9 2 B0 01 7F 1 --- CC: Modulation

thanks

Title: Re: Insert Data Mapping for Controller
Post by Peter L Jones on Sep 13^th, 2008, 2:44pm

Install MIDI Yoke.
Install MIDI OX.

In MIDI OX, open your hardware MIDI Input and MIDI Yoke Out 1.
In your DJ Software, open MIDI Yoke Input 1.

You've not said what mapping you want to do.

For example, let's map CC1 64 through 95 to CC2 0 to 127.

In MIDI OX:
1) Options->Data Mapping...
2) "Turn Map On (after OK)" checked
3) Insert...
4) When Input Matches: "Channel: Any; Event Type: Ctrl; Min1: 1; Max1: 1; Min2: 64; Max2: 95; Clone: not checked"
5) Set Output to: "Channel: Match Input; Event Type: Match Input; Min1: 2; Max1: 2; Min2: 0; Max2: 127; Delay: 0"
6) OK
7) OK
8) Bring up the Raw Input Monitor (fourth toolbar icon)
9) Bring up the Main Output Monitor (fifth toolbar icon)
10) Send a series of CC1 messages and see how they're mapped