MIDI-OX User Forum - Print Page


    
      
        MIDI-OX User Forum
        (http://www.midiox.com/cgi-bin/yabb/YaBB.pl)
      

        MIDI-OX >> Mapping Questions >> Mapping Boss GT-100 to Ableton Live
        
(Message started by: Lionsharz on Aug 15^th, 2012, 12:57pm)

Title: Mapping Boss GT-100 to Ableton Live
Post by Lionsharz on Aug 15^th, 2012, 12:57pm

Hi,

I'm trying to get the four numbered pedals on my Boss GT 100 to trigger clips in Ableton Live. No joy though. They output Program Change messages and somehow I need them to output CC messages.

Any help on this one?

Title: Re: Mapping Boss GT-100 to Ableton Live
Post by siaguitar on Jan 1^st, 2013, 7:33pm

Hey, I have a GT10 and i am trying to do the same exact thing, i managed to change the routing and now i get cc# and also as i change the bank i get other cc#s, so essentially for every patch i can get a new cc#.
but the problem occurs when i try to use the yoke, for some reason when i bring the yoke in to picture, i get both values, the before and after! therefore when i do a midi learn in abelton sometimes it works and sometimes it doesn't

Title: Re: Mapping Boss GT-100 to Ableton Live
Post by 4x4uk on Jan 6^th, 2013, 6:43am

the boss uniits for the numbered pedals when in normal mode will only output PC messages in the following format

cc 0 000
pc xxx

in manual mode however they will out put cc messages if I remember corrrectly cc65, cc66 cc67 cc68

if your in normal mode and you want to get cc messages to use in ableton then
Just map the PC Message to the cc message you want with midiox

Make sure if you dont need the program change message for anything else that you dont check the Pass Original Value (Clone) box or you will get the original pc message passed on as well as the new cc message