MIDI-OX User Forum - Print Page


    
      
        MIDI-OX User Forum
        (http://www.midiox.com/cgi-bin/yabb/YaBB.pl)
      

        MIDI-OX >> Mapping Questions >> Map a Split to Oblivion
        
(Message started by: sj1 on Jul 28^th, 2018, 3:19pm)

Title: Map a Split to Oblivion
Post by sj1 on Jul 28^th, 2018, 3:19pm

Hi,

I'd like to map (or filter) the upper split of a keyboard to oblivion (IOW, filter it out.)

Currently I see I can filter out a whole channel (but not a key range within a channel), or I can Map a key range within a channel to a different channel (helpful, but still sends output on the target channel when I would rather not do so).

Is it possible to do what I'm aiming for? If so how?

Thanks!

Title: Re: Map a Split to Oblivion
Post by Breath on Jul 28^th, 2018, 9:36pm

Hi sj1,

Options / Data Mapping ...
If the CLEAR button can be pressed then click it
Click the INSERT button for a new line

When output matches....
Channel = 1-16 or Any
Event type = Note On : Note # Min = split point Max = 127
Velocity Min = -1 Max = -1 (-1 = any value)

Set output to....
Just make the Event Type = Discard

Press OK

Don't forget to Check the 'Turn Map On' next to the OK button in the Data Mapping window.

You can then route the Midi In of your keyboard to .... some Midi out in the Midi Port Routing Window (View / Port Routings...)

All the best
Royce

Title: Re: Map a Split to Oblivion
Post by sj1 on Jul 29^th, 2018, 8:24am

Ah, Output Event Type = Discard

My eye went right past that. Thanks very much! :)