MIDI-OX User Forum - Print Page


    
      
        MIDI-OX User Forum
        (http://www.midiox.com/cgi-bin/yabb/YaBB.pl)
      

        General >> General Board >> midiox/yoke and B4
        
(Message started by: cutlerr on Jun 7^th, 2003, 1:19pm)

Title: midiox/yoke and B4
Post by cutlerr on Jun 7^th, 2003, 1:19pm

I must be extremely thick, all I want to do is convert a swell pedal output BF 0B nn (ch16) to B0 0B nn (ch1) for the B4. I've setup a midi data mapping transform and port activity says that the translation works. But, however I set the midi devices a can't get a peep out of the B4. B4 works fine from mpu401 direct so presumably I'm not mapping devices correctly. Please help while I still have a few hairs left.
Ray.

Title: Re: midiox/yoke and B4
Post by Jamie OConnell on Jun 7^th, 2003, 8:15pm

Check this thread first. If that's not the problem we can investigate further:
http://www.midiox.com/cgi-bin/yabb/YaBB.pl?board=query;action=display;num=1053072104

Title: Re: midiox/yoke and B4
Post by cutlerr on Jun 8^th, 2003, 9:49am

Thanks for the response Jamie, I'm a total thicko, I just realised that I had a copy of myokent.dll in the midiox folder. I removed it and bingo, the B4 fired-up. Sorry to bother you.
Cheers.
Ray.

Title: Re: midiox/yoke and B4
Post by Jamie OConnell on Jun 8^th, 2003, 12:41pm

Thanks for following up! I often neglect to consider that a loose copy of myokent.dll can be a problem, and I am glad you figured it out. Perhaps this thread will help some others who may have the same predicament.