MIDI-OX User Forum - Print Page


    
      
        MIDI-OX User Forum
        (http://www.midiox.com/cgi-bin/yabb/YaBB.pl)
      

        MIDI-OX >> Questions and Discussion >> Error Message when sending through Pro Tools
        
(Message started by: powerjoe on Nov 19^th, 2004, 8:02pm)

Title: Error Message when sending through Pro Tools
Post by powerjoe on Nov 19^th, 2004, 8:02pm

Hey all!

I hope the new season is treating everyone well!

I am trying to use Midi-Ox to send a data dump through Protools (Digi 002) to an external Midi triggering device (TrapKat). I am receiving an error however that says the following:

"Didgesign Digi 002 port 1: Undefined External Error"

Has anyone come across this problem using this utility or something like it? And if so, how did you remedy it, or what would you suggest I try to make it work?

Thanks very much all!

--------------------
Joel DuBay

Title: Re: Error Message when sending through Pro Tools
Post by Jamie OConnell on Nov 22^nd, 2004, 6:13pm

I don't know what that error report means, but try slowing down transmission (by inserting delays). View | SysEx... and then SysEx | Configure...

Title: Re: Error Message when sending through Pro Tools
Post by powerjoe on Dec 3^rd, 2004, 7:57pm

The delay reading was "60". I upped it to 150, still no go. What else might I be doing wrong?