MIDI-OX User Forum - Print Page


    
      
        MIDI-OX User Forum
        (http://www.midiox.com/cgi-bin/yabb/YaBB.pl)
      

        MIDI-OX >> Questions and Discussion >> bcr2000 + softsynth + xv5050 and nordlead2
        
(Message started by: piano on Mar 14^th, 2005, 5:06am)

Title: bcr2000 + softsynth + xv5050 and nordlead2
Post by piano on Mar 14^th, 2005, 5:06am

HI!. I have bought a BCR2000 from behringer to control all my live stuff. I want to use Softsynths like the B4 and pro53 at the same time as my roland xv5050 and clavia nordlead 2. my problem is that the bcr2000 copy the signal from my masterkeyboard and I got signal in at midi channel 1. I can set different midi channels at the knobs at the bcr2000 - så thats no problem controlling diferent midi chanels (syths) with it, but the masterkeyboard only send on midi 1 - so thats my problem. What I think is the best way to do this is to use midi-ox. I have allredy set up midi yoke and midi out in midi-ox - so i can play at all mididevices at the same time at channel 1. is it posible to copy the input value and send to a spesific midi out channel at the midi out? then i could set yoke 1 to midi 1, yoke 2 to midi 2, midi out 1 to midi out 3 and so on.. and i could play and control the diferent synth at the same time! best regards!

Title: Re: bcr2000 + softsynth + xv5050 and nordlead2
Post by Peter L Jones on Mar 14^th, 2005, 2:00pm

It's possible to:

a) have a patch map that sets the channel number
b) change the patch map based on received program change messages
c) filter data based on channel number
d) open Yoke junctions multiple times (both inputs and outputs)
e) route one input message to multiple outputs
f) replicate the input message

With that lot, yes, you can get what you're after.